Fish tales

The disassembly and cleaning of the playfield are ready. It got a first coat of wax while disassembled, while it is easy to access all areas and it will have a second coat later on. I have also started the assembly but stopped at the point at the picture. I do still need the drive belt of the fishing reel and a lamp holder for the center bumper. I’ll wait with the installation of the boat until the lamp holder has been changed. It’s much easier to work with the bumper while having a hole in the playfield to stick the hand through.

All parts that have been taken out of the playfield have been cleaned and polished before putting them back.

 

 

The boat was disassembled and cleaned

 

The Stretch the truth meter has got five new lamp rubbers. The middle one was of another shade than the other four and to make sure they all look the same I changed all five. I also changed the flasher to a yellow one. I’m not sure what it will look like when playing, but it is easy to change it back to a clear one if it doesn’t look good.

 

The button at the fishing rod handle was lose so I took the handle apart to fasten it. At the same time I polished the handle.  The screws holding the two parts together were quite rusty so I repainted them satin black.

 

The plastic ramp is cleaned and polished. It is cracked by one of the screw holes, the right side of the upper left entrance. It was mounted using a pair of washers clamping the ramp in place. I will put it back I the same way since a new ramp is quite expensive.